AEG 88101 KF-N Installation And Operating Instructions Manual page 23

Problem
Display is switching be-
tween two heat settings
flashes
is lit
and number are dis-
played
and minus are displayed Light rays that are too
If you are unable to remedy the problem by following the above
suggestions, please contact your dealer or the Customer Care De-
partment.
1
Warning! Repairs to the appliance are only to be carried out by quali-
fied service engineers. Considerable danger to the user may result from
improper repairs.
3
If the appliance has been wrongly operated, the visit from the customer
service technician or dealer may not take place free of charge, even
during the warranty period.
Possible cause
Power management is re-
ducing the power of this
cooking zone
Unsuitable cookware
No cookware on the cook-
ing zone
The diameter of the bot-
tom of the cookware is too
small for the cooking zone
Overheating protection for
the cooking zone has been
triggered
Safety cut-out has been
triggered
Electronics fault
strong on the control pan-
el, for example bright sun-
light
Remedy
See the section "Switching
the power function on and
off"
Use suitable cookware
Place cookware on the
cooking zone
Move onto a smaller cook-
ing zone
Use suitable cookware
Switch off the cooking
zone. Switch the cooking
zone on again
Switch off the cooking
zone. Switch the cooking
zone on again
Disconnect the appliance
from the electrical supply
for a few minutes (Take the
fuse out of the house's wir-
ing system)
If after switching on again,
is displayed again, call
the customer service de-
partment
Briefly shade the control
panel, for example with
the hand Acoustic signal
sounds, appliance switches
itself off Switch appliance
on (again)
51