Connection - Cello Stradivari Series Owner's Manual

7

CONNECTION

All the Stradivari Speakers have tri-wire capability. This means the high, midrange
and low frequency cross-overs have separate inputs. The cross-over inputs are located
at the rear of each speaker and are accessed through a total of six 1/4-20 threaded
terminals with nuts for each cross-over. These terminals are arranged in three pairs.
The top pair is the high frequency section. The middle pair is the midrange section.
The bottom pair is the low frequency section. While facing the rear of the speaker the
three positive input terminals are on your right and are designated by a red dot. The
three negative input terminals are on your left and are designated by a black dot.
The Grand Masters have two cross-over boards and therefore two sets of terminals.
Connect your positive left channel speaker leads to the positive terminals of your left
speaker and your negative left channel speaker leads to your negative terminals of
your left speaker. Repeat this for the right channel.
Caution: Do not over tighten nuts. Tighten so they are snug then tighten an
additional quarter turn.
STRADIVARI SPEAKERS