Table of Contents
Advertisement
3
|
Maintenance
The finish of the Serafin Active Speakers is a clear lacquer over wood or over piano
black polyester paint.
Ammonia based glass cleaner and a soft cloth will work well to preserve the shine
and remove finger prints. When cleaning, wipe in a circular motion and do not rub
too forcefully.
Caution: Make sure not to use any and cleaners or polishes with abrasives since
these may damage the finish.
Connection
All Serafin Speakers are internally wired connecting the amplifiers to the speakers.
Connect your preamplifier's left channel output to the left speaker input using a cable
with a 3 pin Fischer connector and the right channel preamp output to the right
speaker input with a 3 pin Fischer connector. The Serafin Active Speakers are
interchangeable and either may be set up as the left or right channel.
A signal common float switch located on the rear panel allows input ground to be
floated to prevent ground loops in cases where necessary.
Advertisement
Table of Contents
