Receiver Frequency Selection - Crown FM600 User Manual

2.4 Receiver Frequency Selection

If you have a transmitter equipped with the receiver option, you will need to set the receiving
or incoming frequency.
1. With the top cover removed, locate the receiver module and the two switches (labeled
SW1 and SW2).
J1
Receiver
Module
J2
2. Use the adjacent chart to set the switches for the desired incoming frequency.
3. For frequencies in the Japan FM band, short pins 7&8 on J1 on the receiver card.
4. For 75us pre-emphasis short pins 3&4 and 5&6 on J2 of the Receiver card.
5. For 50us pre-emphasis short pins 1&2 and 7&8 on J2 of the Receiver card.
6. After setting the frequency, replace the top cover and screws.
2-8
Illustration 2–11 Receiver Module Switches
Frequency
Switches
FM600 User's Manual