Receiver Frequency Selection - Crown FM250G User Manual

Rev A
2.4

Receiver Frequency Selection

If you have a transmitter equipped with the receiver option, you will need to set the
receiving or incoming frequency.
1. With the top cover removed, locate the receiver module and the two switches
(labeled SW1 and SW2).
Receiver
Module
Illustration 2–7 Receiver Module Switches
2. Use Table 2-2, Receiver Frequency Selection, to set the switches for the desired
incoming frequency.
After setting the frequency, return to Section 2.3.1, Modulation Compensator, to set
the modulation compensator.
Note: If you requested it, the FSK chip on the RF Exciter Board has been
pre-programmed for your operating frequency. This chip is
replaceable. Should you need to change the location of your
translator, contact Crown Broadcast for a replacement chip with your
new FSK ID.
Replace the top cover before operating the transmitter.
2—6
Frequency Selection
Switches
FM250G User's Manual