A A D D J J U U S S T T I I N N G G T T H H E E L L E E V V E E L L O O F F C C O O N N D D U U C C T T I I V V I I T T Y - AEG Electrolux LAVATHERM T6031TA Operating Instructions Manual

A A d d j j u u s s t t i i n n g g t t h h e e l l e e v v e e l l o o f f c c o o n n d d u u c c t t i i v v i i t t y y
Your dryer allows you to regulate the sensitivity of the drying sensor
based on conductivity values of the water by using the following proce-
dure.
E E i i n n s s t t e e l l l l u u n n g g s s v v o o r r g g a a n n g g
Turn the programme selector dial to switch on
the appliance. In selection mode, press simul-
taneously the buttons 1 1 and 3 3 . Press the but-
tons down until the pilot lights above each
ones begin to flash and one of the pilot lights
indicating TROCKNEN,
KNITTRTSCHUTZ remains lit.
A A d d j j u u s s t t i i n n g g t t h h e e l l e e v v e e l l o o f f c c o o n n d d u u c c t t i i v v i i t t y y : :
Press the START/PAUZE button sequentially: the level of conductivity is
indicated by the phase pilot lights, which light in various combinations as
follows:
Lights
KNITTRTSCHUTZ
ABKÜHLEN
TROCKNEN
Normally, the appliance is factory-set to the highest level; however,
certain models may be configured differently.
M M e e m m o o r r i i z z i i n n g g t t h h e e n n e e w w s s e e t t t t i i n n g g : :
Simultaneously press down the buttons 1 1 and 3 3 until the previous
drying cycle time appears again on the display and the buzzer sounds.
ABKÜHLEN or
Conductivity degree
Low
Medium
High
µ S /cm i 25°C
< 300
300 - 600
> 600
1 1 7 7