Table of Contents
Advertisement
Problem
Drying cycle ends
shortly after pro-
gramme starts. Display
shows: PLEASE CHECK
THE LOAD.
Washing is heavily
creased.
Changing bulb for inside light
Only use a special bulb which is designed specially for dryers. The spe-
cial bulb is available from the after-sales service,
ET-Nr. 112 552 000-5.
1
Warning! Do not use standard bulbs! These develop too much heat and
may damage the machine!
1
Warning! Before replacing the bulb, disconnect the mains plug; with a
permanent connection: fully unscrew or deactivate the fuse.
1. Unscrew covering bonnet from above bulb (this can be found directly
behind the loading aperture, at the top; refer to "Description of ma-
chine" section.)
2. Replace defective bulb.
3. Screw covering bonnet back down.
1
Warning! For reasons associated with safety, the covering bonnet must
be screwed down tightly. If this is not done, the dryer must not be op-
erated.
30
Possible cause
Not enough washing load-
ed or washing loaded is too
dry for selected programme.
Possibly too much washing
was loaded.
Remedy
Select Timed Drying or higher
degree of dryness (e. g., INTEN-
SIVE DRY [INTENSIEF-DROOG]
instead of STORAGE DRY
[KAST-DROOG]).
Observe recommended loads.
Advertisement
Table of Contents
