AEG Electrolux FAVORIT 80873 User Manual page 26

Electrolux dishwasher
Table of Contents

Advertisement

26
What to do if...
Display message and malfunction
• intermitted audible signal
• message OPEN THE TAP in the display
The dishwasher does not fill with water
• intermitted audible signal
• DRAIN BLOCKEDmessage in the display
The dishwasher will not drain
• intermitted audible signal
appears in the display
Anti-flood device is activated
The programme does not start.
Once these checks have been carried out, switch on the appliance: the programme will
continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local Service
Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher
door.
So that you always have these numbers at hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
The dishes are not clean
• The water tap is blocked or furred with lime-
• The water tap is turned off.
• The filter (where present) in the threaded hose
• The water inlet hose has not been correctly
• The sink spigot is blocked.
• The water drain hose has not been correctly
• Close the water tap and contact your local
• The dishwasher's door has not been properly
• The main plug is not plugged in. Insert the
• The fuse has blown out in the household fuse
• Delay start has been set.
The wash results are not satisfactory
• The wrong washing programme has been se-
Possible cause and solution
scale.
Clean the water tap.
Turn the water tap on.
fitting at the water inlet valve is blocked.
Clean the filter in the threaded hose.
laid or it is bent or squashed.
Check the water inlet hose connection.
Clean out the sink spigot.
laid or it is bent or squashed.
Check the water drain hose connection.
Service Force Centre.
closed. Close the door.
main plug.
box.
Replace the fuse.
If dishes are to be washed immediately, cancel
the delay start.
lected.

Advertisement

Table of Contents
loading

Table of Contents