Ryobi LCS-180 Owner's Operating Manual page 14

Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an Authorized Service Center.
BATTERIES
This product will accept Ryobi One + 18 V lithium-ion
batteries or 18 V nickel-cadmium batteries. Length of
service from each charging will depend on the type of
work you are doing.
The batteries for this product have been designed to
provide maximum trouble-free life. However, like
all batteries, they will eventually wear out. Do not
disassemble battery pack and attempt to replace the
batteries. Handling of these batteries, especially when
wearing rings and jewelry, could result in a serious burn.
To obtain the longest possible battery life, we suggest the
following:
For lithium-ion batteries:
 Remove the battery pack from the charger once it is
fully charged and ready for use.
For battery pack storage longer than 30 days:
 Store the battery pack where the temperature is
below 27°C and away from moisture.
 Store battery packs in a 30%-50% charged condition.
 Every six months of storage, charge the pack as
normal.
For nickel-cadmium batteries:
 Remove the battery pack from the charger once it is
fully charged and ready for use.
For battery pack storage longer than 30 days:
 Store the battery pack where the temperature is
below 27°C.
 Store battery packs in a "discharged" condition.
ACCESSORIES
Look for these accessories where you purchased this
product:
 150mm. Thin Kerf blade (681344001)
 Wrench (680002001)
 Edge guide (670957007)
WARNING:
Current attachments and accessories available for
use with this product are listed above. Do not use
any attachments or accessories not recommended
by the manufacturer of this product. The use of
attachments or accessories not recommended can
result in serious personal injury.
English
9