Safety Instructions For The Installer - AEG C6100M-in Installation And Operating Instructions Manual

1

Safety Instructions for the Installer

• A device must be provided in the electrical installation which allows
the appliance to be disconnected from the mains at all poles with a
contact opening width of at least 3 mm.
Suitable isolation devices include line protecting cut-outs, fuses
(screw type fuses are to be removed from the holder), earth leakage
trips and contactors.
• In respect of fire protection, this appliance corresponds to type Y
(EN 60 335-2-6). Only this type of appliance may be installed with a
high cupboard or wall on one side.
• Drawers may not be fitted underneath the hob.
• The installation must guarantee shock protection.
• The kitchen unit in which the appliance is fitted must satisfy the sta-
bility requirements of DIN 68930.
• For protection against moisture, all cut surfaces are to be sealed with
a suitable sealant.
• On tiled work surfaces, the joints in the area where the hob sits must
be completely filled with grout.
• On natural, artificial stone, or ceramic tops, the snap action springs
must be bonded in place with a suitable artificial resin or mixed ad-
hesive.
• Ensure that the seal is correctly seated in the frame and that it is
seated against the work surface without leaving any gaps. Additional
silicon sealant must not be applied; this will make removal more dif-
ficult when servicing.
• The hob must be pressed out from below when removed.
• Clean the edge of the cut-out groove.
• Fit the single sided adhesive strip, supplied with the hob, onto the
cut-out groove. The joining point of the two ends should be in the
middle of one of the sides of the cut-out. After cutting the correct
length (allow a few millimetres) simply press the two ends against
each other.
38