Table of Contents
Advertisement
GB
INSTALLATION
POSITION
Place the freezer horizontally on a firm surface, resting on all
four wheels.
The room should be dry and adequately ventilated.
Temperatures of the external environment have an impact on
the energy consumption of the freezer. Therefore:
- do not place the freezer in a position exposed to sunshine or
beside a radiator
- position it where the temperature of the environment
corresponds to the
climatic classification for which the freezer was designed.
Climatic classification
SN
N
ST
T
If the freezer has been handled standing on end it should be
allowed to stand in normal position for about 12 hours before
switching it on
E E L L E E C C T T R R I I C C A A L L R R E E Q Q U U I I R R E E M M E E N N T T S S
Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating
plate, located on the backside of the appliance.
WARNING:
This appliance must be earthed.
Please ensure that when the appliance is installed it is easily
accessible for the engineer in the event of a breakdown.
WARNING:
The enclosed wheels must be fitted before
switching on the freezer.Do not use the appliance
without the wheels because it may result
malfunction.
S S W W I I T T C C H H I I N N G G O O N N
Before switching on, the freezer should be cleaned inside.
See under "Maintenance".
Allow the freezer to run for several hours before placing
food inside.
FITTING WHEELS
The wheels are fitted as shown in the drawing, using the
enclosed fitting key.
If the freezer is equipped with wheels with brake, you can
brake the freezer by pushing the brake down and you can
loosen it by pushing it up as shown in the figure.
To ensure the stabilization of the freezer you have to brake
two wheels at the same time.
4
oven, or any other source of heat.
Ambient temperature limits
From to
+10 to +32 C
+16 to +32 C
+18 to +38 C
+18 to +43 C
Advertisement
Table of Contents
