Unpacking and Checking Contents
Unpacking
NOTE: Before beginning assembly, check
that all parts are included. If you are miss-
ing any part, do not assemble this acces-
sory. Call 1-800-4-RIDGID or E-mail us at
info@ridgidwoodworking.com to get the
missing part. Sometimes small parts can
get lost in packaging material. Do not
throw away any packaging until the acces-
sory
is
completely
attached to your power tool. Check pack-
aging for missing parts before contacting
RIDGID.
A
NOTE: Only ONE spring pin is required at
the carry handle end of the stand. This
spring pin locks the legs in the set-up or
knock-down
position.
Assembly
Assembling the Lower Foot
1. From carton and bag of loose parts
remove the following:
2 Hex Bolt, M6 x 41mm
4 Curved Washers M6
2 Hex Nuts M6
2 Assembly Wrenches
1 Lower Foot
1 Stand Assembly
*Some additional tools may be required to
attach your power tool to the stand. See
"Mounting Power Tools" section of this
manual.
assembled
and
Instructions
to
List of Loose Parts
Item
A Stand Assembly ...............................1
B Lower Foot .......................................1
C Bag of Loose Parts ..........................1
D Owners Manual ................................1
C
Carry
Handle
change the location of this spring pin are
described later in the "Assembly" section
of this manual.
Tools Needed for Assembly *
M6 x 41mm
M6 Curved
Washer
Stand Assembly
4
Part Name
D
B
Assembly Wrench
(2 Supplied)
Hex Bolt
Lower
Foot
Lock Nut
Qty.
M6