What To Do If; Troubleshooting By Yourself - AEG LAVATHERM 59880 User Manual

26

What to do if ...

WHAT TO DO IF ...

Troubleshooting by yourself

1)
Problem
Dryer does not
work.
Unsatisfactory
drying results.
Loading door
does not close
Err
(Error) on
5)
the LCD.
No drum light
Abnormally
elapsing time
5)
on the LCD
Programme
inactive
Drying cycle
to short
Drying cycle
6)
to long
1) In case of error message on the LCD (e.g.
programme. Press the START PAUSE button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaningchapter
4) see Machine settings chapter
Possible cause
Dryer not connected to mains supply.
Loading door opened.
The START PAUSE button not pressed.
Incorrect programme set.
Fluff filters clogged.
Heat exchanger clogged.
Max. loading exceeded.
Covered ventilation grill.
Residue inside the drum.
High water hardness.
Filters not locked in place.
Attempt to change parameters after
start of the programme.
Programme selector in OFF position.
Defective light bulb.
Time to end is calculated on the basis
of: type, volume and dampness of laun-
dry.
Full water reservoir.
Small laundry volume./Too dry laundry
for selected programme.
Fluff filters clogged.
To high loading volume.
Laundry insufficiently spun.
Particularly high room temperature -
no machine fault.
E51
Plug in at mains socket. Check fuse in
fuse box (domestic installation).
Close loading door
Press the START PAUSE button.
Set suitable programme.
Clean fluff filters.
Clean heat exchanger.
Respect max. loading volume.
Uncover ventilation grill in base area.
Clean the drum inside.
Set suitable water hardness
Install fine filter and/or snap course fil-
ter into place.
Turn the dryer off and on. Set requested
parameters.
Turn it to DRUM LIGHT (if available) or
to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
Empty water reservoir
PAUSE button.
Select time programme or higher drying
level (e.g. EXTRA DRY ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
- only dryers with the LCD): Switch the dryer off and on. Set
Remedy
2)
3)
3)
4)
.
3)
, press START