Transferring Calls - BT FREESTYLE 60 User Manual

Your additional handset is
registered automatically and you
will hear a long confirmation
beep and the light will stop
flashing.
Check that your additional handset
is registered correctly by pressing the
button. The talk light should
remain constantly lit and you will
hear a dial tone. If you do not hear
a dial tone your additional handset
is either out of range of the base unit
or it has not been registered properly,
or the base unit line cord is not
plugged in.
Each additional handset must
be assigned an identity
number (2, 3 or 4) to be used
when transferring calls. Your
Freestyle 60 handset is already
registered as HANDSET 1. A
Freestyle 6 additional handset
is pre-set as HANDSET 2.
However, further additional
handsets can be numbered as
they are added.
Press the
Press the
Enter the handset number
between
button.
button.
and .
Press the
button. You will hear a beep
confirming that the new
number has been stored.
Make a note of the handset number by
writing it on the directory label on the
back of the additional handset.
You can transfer calls between handsets
that are registered to the base unit.
During your call press the
handset number that you want
to transfer the call to.
The called handset will ring.
Press the
ringing handset to speak to
the caller.
If the call is not answered
within 30 seconds the original
calling handset will ring.
If after a further 30 seconds
the call is not taken the caller
will be disconnected.
button and then the
button on the
16