Troubleshooting - GMC ATBR1650K Instruction Manual

Troubleshooting

Trouble
Nailer skips when driving
brad nails.
Air leaking near the top of
the tool or in trigger area.
Nailer runs slow or has loss
of power.
Air leaking near the
bottom of the tool.
Tool jams frequently.
WARNING:
Disconnect tool from air supply before performing any cleaning and maintenance procedures.
Possible cause
Dirt in the nose piece.
Dirt or damage prevent nails or pusher
from moving freely in magazine.
Inadequate air flow to nailer.
Loose screws.
Nailer not lubricated sufficiently.
Exhaust port in the cap has been
blocked.
Loose screws.
Incorrect fasteners.
Damaged fasteners.
Magazine is dirty.
Suggested remedy
Drive channel needs to be cleaned.
Magazine needs to be cleaned.
The fittings, hose or air compressors
needs to be checked.
Tighten screws.
Nailer needs to be lubricated.
Damaged internal parts needs to be
replaced by an authorized service centre.
Tighten screws.
Verify approved fasteners of correct size.
Replace with undamaged fasteners.
Clean magazine.
14