Setting Up; Parent Unit - BT 100 User Manual

8217 Baby Monitor 100 UG Iss.2 [4]

Setting up

Parent unit

1. Plug the mains power cable into the socket marked
back of the Parent unit charger.
Connect the other end to the mains power and switch on.
2. Remove the battery compartment cover and insert the 2 x AA
rechargeable batteries into the battery compartment on the
Parent unit and replace the battery compartment cover as
shown. You should always ensure you have inserted batteries
in the Parent unit.
3. Slot the Parent unit into the charger, the red charging light
comes on. Charge the batteries for 16 hours before switching
on the Parent unit.
If you experience any problems, please call the Helpline on 0870 240 4745 or email helpline@btbabymonitors.co.uk
15/6/07
BT Baby Monitor 100 – Issue 2 – Edition 4 – 15.06.07 – 8217
10:35 Page 5
IMPORTANT
Your BT Baby Monitor 100 is designed
on the
to be an aid and should not be used as
a substitute for responsible and proper
adult supervision.
Make sure the Baby unit, Parent unit
and mains adapter cable are kept out
of reach of your baby – at least one
metre away.
Never place the Baby unit inside your
baby's cot, bed or playpen.
Never cover your Parent or Baby units
(e.g. with clothes, towels or blankets).
Never use or place your Parent or Baby
units in moist places or near water.
If travelling abroad, make sure that the
voltage shown on the mains power adapter
corresponds to the local mains power
before connecting to the power supply.
Always dispose of batteries in
accordance with applicable waste
disposal regulations, never in your
household rubbish.
Battery performance - Parent unit
Rechargeable batteries in the
Parent unit give up to 14 hours
continuous performance.
Please note however, that new
batteries do not reach full capacity
until they have been in normal use for
several days.
5