Brandt Instructions For Use Manual page 6

EN 4 / PROGRAMMING YOUR MACHINE
•DESCRIPTION OF THE CONTROL PANEL AND THE LCD SCREEN
Temperature adjustment
Type of textiles
1
Start/Pause
Spin speed adjustment
SYNTH.
Cycle 1: 22 End 20: 30
Weighing
Incident warning light
Information:
All the displays shown in these instructions are provided only as examples. The actual displays can vary depending on the model, the
selected programme and the programming tim
•DETAILS OF THE VARIOUS DISPLAYS ON THE LCD SCREEN
•Message display
Your washing machine communicates with you by means of clear text messages, which:
— Guide you through setting up,
— Gives you information, during programming, on the selected cycle (cycle length, finishing time,
temperature and maximum authorised spin speed, etc.),
— Tells you, during the cycle, the time remaining before the cycle ends and the finishing time,
— Also tells you, if a problem occurs, what the problem is and how to remedy it. When the machine
detects a problem, the symbol flashes and a continuous "beep" can be heard.
•Weighing
During the first few minutes of the"Cotton" programme, your washing machine automatically estimates
how much washing has bee introduced.
During this period, these 4 segments progressively appear and disappear.
When weighing is complete, one, two, three, or all four segments will remain constantly lit, depending
on the load detected.
Selection of setup parameters
LCD screen
3 A
SYNTH. 40°C
Cycle 1: 22 End 20: 30
2 4 5
Options
+
Children's safety
Message display zone
40°C
Cycle progress
+ setting for delayed washing
On/Off
7 8
900
6
Entry into the menu
+ confirmation of
setup parameters
900
Children's safety
Door safety system
Audible end of cycle signal
18
•USE
Advice:
Familiarise yourself with the
operation of the buttons, the knobs
and the screen.
Programme the current time when you
first switch on or after a power failure.
Set your programme after you have
put your washing in the machine.
•OPERATION OF THE
CONTROLS
— All the buttons are micro-switches
and do not remain depressed..
— The selector 7 is rotary and is used:
- When setting up, to select the various
operating parameters for your
machine
- During programming, to set Delayed
Washing.
— The "MENU" key 6 is used:
- When setting up, to confirm your
selections
- Before the cycle starts, to return to
"Parameter Selection" mode to enable
you to modify the parameters if you
wish.
•Confirm/Pause:
— The "Start/Pause" button
to confirm the program you have
chosen and temporarily to stop a cycle
while it is running.
• Cancel:
— You can cancel your selections at any
time by pressing the "On/Off" button
8
Display
SET the time
Turn the knob
SYNTH. 40°C
Cycle 1: 22 End 20: 30
SYNTH. 40°C
Cycle 0: 22 End 16: 30
Incident d07
Close the door
COTTON 60°C 1200
Cycle 1: 58 End 20: 30
COTTON 60°C 1200
Cycle 1: 58 End 20: 30
2 is used
900
800