Important Safety Notes - Please Read Before Operating Pack - Bowens DUO 4800 PACK Operating Instructions Manual

Important Safety Notes - Please Read Before Operating Pack

Please read and follow these basic safety instructions:
READ and UNDERSTAND the instructions and specifications.
ONLY connect to an AC (Alternating Current) power supply.
NEVER connect to a DC (Direct Current) supply.
ALWAYS use a grounded AC outlet.
ALWAYS use a three core cable of at least 10 or 15 Amp rating as supplied.
WHEN practical, unplug the Pack from the electrical outlet when not in use.
ALWAYS remove the power cord by gripping the plug, NEVER pull the cord.
ALWAYS ensure that any extension cord used has a suitable current rating to
prevent overheating. NEVER use coiled extension cords.
NEVER replace the fuse with one of a different type or rating. See Specification
for correct value/type of fuse.
ALWAYS avoid placing AC power cords and Flash Head cables where they can
be tripped over.
NEVER place heavy objects on top of the AC Power cord or Flash Head cables
and avoid running them over sharp or hot objects.
NEVER use the equipment with damaged cables. Have them replaced as soon as
possible. NEVER attempt to repair them yourself.
NEVER use the Pack or Flash Heads in an environment where moisture, water
vapour or inflammable liquids, vapour or materials may come into contact with the
Pack or Flash Heads. The flash output as well as the modelling lamps can cause
ignition of or damage to materials that may come into direct or close contact with
the Flash Heads.
ALWAYS keep ALL vents in the Pack and Flash Heads clear of obstructions at all
times.
ONLY switch the Pack 'ON' AFTER the Flash Head/Heads has/have been
correctly connected.
ALWAYS ensure that the Flash Head cable connectors are correctly fitted before
use.
ALWAYS remove the Flash Head covers before using.
ALWAYS turn OFF the Pack, disconnect from the supply, unplug the Flash
Head/Heads and allow them to cool before:
If the Pack is not used for more than a couple of months then it is advisable to just
switch the Pack on periodically for an hour or so with the FLASH variators set to
maximum - there is no need to use a Flash Head.
a). Replacing the modelling lamp in Flash Head.
b). Replacing the flash tube in Flash Head.
c). Replacing the fuse in Flash Head or Pack.
- 6 -