Flash Tube Replacement - Bowens ESPRIT digital DX1000 Operating Instrctions

Esprit Digital Operating Instructions
QUICK START GUIDE
The Esprit Digital is very simple to operate once the user has become familiar with the controls.
Detailed operating instructions are given after this Quick Start Guide.
Mounting
Select a stand or support system of suitable weight and dimensions to ensure stable operation of
the unit. The mounting bush on the "L" bracket allows the unit to be mounted two different ways
(Fig. 3). Method A is preferred, however method B can be used if the light needs to point
downwards. Ensure that the clamp knob is fully tightened.
A
Figure 3
Protective Cap
Push the latch knob back towards the rear of the unit, rotate and remove the plastic protective
cap. Always refit the cap when transporting the unit to avoid damaging the flash tube or modelling
lamp. NEVER operate the unit with the cap still in place.
Modelling Lamp
Ensure that the unit is switched off and disconnected from the supply. Confirm that the lamp and
flash tube are securely fitted, particularly before first use or after transporting the unit. Refer to the
section on fitting the modelling lamp if required.
Reflector/Accessory System
A range of reflectors and accessories are available for the Esprit units. Slide the neck of the
reflector/accessory over the front of the unit. Align the three pegs with the three slots in the
retaining ring, press down and turn clockwise to lock. Ensure that the latch knob is in the closed
position.
To remove reflector, push the Latch Knob towards the rear of the unit, turn the reflector fully
counter-clockwise and withdraw.
B
4

FLASH TUBE REPLACEMENT

Ensure that the unit is switched off and disconnected from the supply before replacing the flash
tube assembly. Wait a few minutes for the lamp and tube to cool and for the unit to self-discharge,
it is advisable to leave the unit for as long as possible before changing the flash tube.
Remove the protective cap and unwind the twisted Trigger wire from the trigger terminal.
Carefully pull the flash tube assembly out of the unit. To replace, hold the replacement flash tube
assembly as shown in Fig.4, locate the three brass sockets onto the plugs in the front of the unit.
Press down evenly until all of the plugs and sockets are fully engaged. Pass the trigger wire
through the hole in the trigger terminal tag and wind around the tag, ensuring the trigger wire is
kept well clear of the metal top hat. Excess wire may be trimmed off.
Always replace with the correct flash tube assembly, BW-1079 UV coated.
Figure 4
13