Table of Contents
Advertisement
g
Cleaning and care
Unplug from the mains.
1
The fryer must be left to cool
1
down for 60 minutes after frying.
• After each use, wipe the housing and
lid with a soft, damp cloth to remove
splashes and spots of fat. Do not use
sharp objects or cleaners.
• The deep fryer should be fully cleaned
every time the oil is changed.
Changing the oil
Small food particles often fall to the
bottom of the oil/fat container(5)
when frying. Since the heater ele-
ment(4) is above the base of the oil/fat
container(5), these particles do not get
stirred up the next time you use the
fryer; they remain at the bottom of the
container. It is sufficient to remove any
food remnants (e.g. with a metal sieve)
after each use.
Heating oil to more than 180°C for
2
long periods reduces its quality. After
using 12 to 15 times or when the oil
foams unnaturally, change the oil as
follows:
Removing the oil/fat contai-
ner(5)
1. Press both the unlocking knobs simul-
taneously. Lid opens half way automa-
tically.
2. Open the lid fully, then tilt it slightly
until the hinge springs out of the
mounting on the control section(2).
3. Remove the lid.
4. Take out the basket(3).
5. Pull the control section(2) firmly
upwards and off the retaining lugs on
the housing(6).
6. Take the oil/fat container(5) out of the
housing.
Tip the used oil out of the oil/fat con-
2
tainer(5) into an appropriate container.
Never pour the oil into the sink or
down the drain.
10
Clean the individual parts of the deep
3
fryer.
The lid(1), basket(3), oil/fat contai-
ner(5) and housing(6) can be washed
by hand or in the dishwasher. The long-
life filter in the lid is automatically cle-
aned at the same time. It should be
ensured the lid with the long-life filter
is only reassembled when completely
dry.
The control section(2) with the heater
1
element(4) must never be submerged
in water or held under running water.
It should only be wiped with a damp
cloth.
• After assembling the deep fryer, fill the
oil/fat container(5) with new oil or
melted fat.
Never mix new oil or fat with used,
always change all the oil or fat.
Technical data
Mains voltage:
Power consumption:
Maximum capacity:
This appliance complies with the follo-
;
wing EC directives:
• 73/23/EEC of 19/2/1973 "Low
voltage directive", including the
modification directive 93/68/EEC.
• 89/336/EEC of 3/5/1989 "EMC direc-
tive", including the modification
directive 92/31/EEC.
Customer service
The highest quality requirements are
placed on our appliances. Should,
nevertheless, a malfunction occur on
which you can find no information in
the operating instructions, please con-
tact your specialist dealer or AEG
Customer Service (addresses are on the
next to last page).
230V
2000W
3.5 litres of oil
Advertisement
Table of Contents
