Electrolux WAGL 2 T 200 User Manual page 17

Electrolux washing machine
Table of Contents

Advertisement

Problem
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The appliance fills with
water and drain imme-
diately.
The washing results
are not satisfactory.
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
Service
• Refer to the information supplied with this
appliance for guarantee condition and
point of contact. The information to give
to the service is on the rating plate.
Possible cause
The water drain hose is dam-
aged.
The washing programme is in
operation.
There is water in the drum.
Incorrect level of the appli-
ance.
You did not remove the pack-
aging and/or the transit bolts.
The load is very small.
The end of the drain hose is
too low.
The detergent you used was
not sufficient or correct.
You did not remove the stub-
born stains before you wash
the laundry.
Incorrect temperature was set.
Too much laundry load.
Possible solution
Make sure that the water inlet hose has
no damages.
Let the washing programme end.
Set the drain or the spin programme.
Adjust the level of the appliance. Refer
to 'Installation'.
Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
Add more laundry in the drum.
Make sure that the drain hose is in the
correct position.
Increase the detergent quantity or use a
different one.
Use special products to remove the
stubborn stains.
Make sure that you set the correct tem-
perature.
Decrease the laundry load.
We recommend that you write the information
here:
Model
(Mod.)
Product number
(Prod. N°)
Serial number
(Ser. Nr.)
electrolux 17
..................
..................
..................

Advertisement

Table of Contents
loading

Table of Contents