Table of Contents
Advertisement
4. Remove the inlet hose behind the appli-
ance.
5. Clean the filter in the valve with a stiff
brush or a towel.
6. Install again the inlet hose. Make sure
that the couplings are tight to prevent
leakages.
TROUBLE SHOOTER AND SERVICE
The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
•
- The appliance does not fill with
water.
7. Open the water tap.
Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (3) of 'To
clean the drain filter'.
If necessary, clean the filter.
Put the drainage duct back and close the
drain filter flap.
Frost precautions
If the appliance is installed in an area where
the temperature can be less than 0 °C, re-
move the remaining water from the inlet
hose and the drain pump.
1. Close the water tap and disconnect the
inlet hose.
2. Put the end of the inlet hose in a con-
tainer and let the water flow out of the
hose.
3. Do the Drain programme and let it op-
erate until the end of the cycle.
4. Turn the programme knob to Stop to
disconnect the appliance from the
power supply.
5. Disconnect the appliance.
Warning! Make sure that the
temperature is more than 0 °C before
90˚
you use the appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
•
water.
•
closed correctly.
•
- The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
- The appliance does not drain the
- The appliance door is open or not
electrolux 15
Advertisement
Table of Contents
