Using 3In1 Detergents - AEG FAVORIT 88080 i User Information

Using 3in1 detergents

These products are detergents with a combined cleaning, rinsing and
salt function.
1. Check whether they are suitable for your water hardness.
Follow the manufacturer's instructions.
2. Place detergent just in the detergent dispenser.
3. With the 3 IN 1 option, select ON, in order to switch on the 3 IN 1 op-
tion (see "Adjusting an option/setting");
symbol line.
Switching on the rinse aid inflow with the 3 IN 1 option
If the 3 IN 1 option is activated and you use 3in1 detergent, it may
come about because of different quality standards in the detergent
that the dishes do not dry sufficiently.
If this happens, proceed as follows:
1. Fill up the dispenser with rinse aid (if it is empty; see section "Adding
rinse aid").
2. Set rinse aid dosage to "2" mechanically.
3. With the RINSE AID setting, select ON, in order to switch on the rinse
aid inflow (see "Adjusting an option/setting").
Ending the use of 3 in 1 detergents
If you want to stop using 3in1 products, please do the following:
1. With the 3 IN 1 option, select OFF, in order to switch off the 3 IN 1 op-
tion (see "Adjusting an option/setting");
symbol line.
2. Fill up the dispensers for salt and rinse aid again, if necessary.
3. Switch the water softener to the highest setting and perform up to
three normal cycles without loading any dishes.
4. Set the water softener to the water hardness in your area.
symbol lights up in the
symbol goes out in the
27