Turn-On Procedure - Fisher CZ-7a PRO Quicksilver Operating Manual

TURN ON PROCEDURE
GROUND BALANCE = 10
AUTO/I.D. = I.D. for normal use in target I.D. mode.
(use AUTO mode for deep search, all-metal, autotune mode)
SENS = 10
VOLUME = 0
NORM/SALT = NORM for normal search areas (use SALT
mode for wet sand hunting)
NOTE: If your headset has volume controls, first adjust your
headset volume controls to minimum and the CZ-7a Pro
volume to maximum. Then gradually increase the headset
controls to a comfortable level when the coil is passed over a
target. Note that small, deep targets now respond with the
same loud zap as large, shallow targets. To defeat the faint-
target, audio boost feature, adjust the CZ-7a Pro volume to 4
or lower.
1. (optional) Adjust your headset volume controls
to minimum, and plug the headphone jack into
the CZ-7a Pro control panel. Leave the headset
around your neck for now.
2. When you first turn the power on, you will
probably notice a momentary display on the
LCD. This is normal for the CZ-7a Pro. Set your
controls as follows:
3. (optional) Put your headset on and gradually
increase the CZ-7a Pro volume to a comfortable
level when the coil is passed over a large,
shallow target.
16