Turn-On Procedure; Ground Balancing - Fisher M-Scope CZ-5 QuickSilver Operating Manual

TURN ON PROCEDURE
2. Hold the search coil waist high, away from any nearby
3. Turn the VOLUME control to 10. A brief bell tone is
4. If you're wearing headphones, reduce the headphone

GROUND BALANCING

When your CZ-5 QuickSilver is properly "ground balanced," it
will have only a minimum response to ground mineralization.
Precise adjustment of the ground control is critical. The higher
the degree of ground mineralization or sensitivity setting, the more
critical it is. Once you adjust it in either the Autotune mode or
Target ID mode, you can switch back and forth between the
two modes without resetting it, unless you increase the sensitivity
level or go from dry sand to wet sand or vice versa. You should
also recheck your setting occasionally as you search since
ground conditions often change rapidly.
If you have difficulty ground balancing, try reducing your
sensitivity level or moving to another spot just in case you are over
a buried piece of metal. In some areas of high ground mineralization
you may not be able to use the "pushbutton" method.
1. Set your controls as follows:
GROUND = 10
DISC = 0 for normal use in target ID mode. (Set DISC to
"Auto tune" for deep search, all-metal Auto
tune mode.
SENSITIVITY = 10
MODE = NORMAL (Unless you're on a wet ocean
beach, in which case set the MODE switch
to SALT.)
VOLUME = OFF
metal.
normal when you turn the VOLUME control on.
If you're in the Auto tune Mode, you'll hear an audio
"threshold" hum. Lower the SENSITIVITY control until
you can just barely hear it.
volume controls to a comfortable level when the search
coil is passed over a large, shallow target.
9