Clarion NAX970HD Owner's Manual page 71

Hdd navigation system
Hide thumbs Also See for NAX970HD:
Table of Contents

Advertisement

Wire Connection
Notes on wire connection
When connecting the plugs and sleeves, be sure to insert the plug until it locks securely. After
completing connections, fasten the cords using cord clamps and tapes.
Cut5 mm.
Fema~'_~Male
Sleeve
----.I
®
~
I
If the male knob is in the shape shown at
@,
cut the female sleeve about 5 mm.
Example of connecting reverse gear or handbrake signal cord
Connect each signal cord using the supplied electro-taps.
From this unit
Tighten with the vehicle side screw and fasten
securely to the vehicle metal part.
3 Electro-tap
1. Place the cord from this unit at the stopper, and fold it back in the direction of the arrow.
2. Pass the vehicle signal cord through, and fold it back in the direction of the arrow.
Vehicle and main unit signal cord
Stopper
Power supply cord from this unit
l
Vehicle and main unit signal cord
~
~po~er
supply cord from this unit
Example of relay usage
Use a special installation kit (relay cord kit), sold separately, prepared specifically for your model. For
applicable models, consult the dealer where you purchased this unit.
Note:
When connecting the main power supply cord (yellow) of the main unit, connect it to
a
spare terminal of this unit.
Ground cord from this unitl
ooo::::::------------------~
I
~
10
NAX970HD

Advertisement

Table of Contents
loading

Table of Contents