Incorporating In Kitchens (Built-In); Protection Against Touching Under Work Surfaces; Removing The Worktop - AEG LAVAMAT W 1270 Instruction Book

Incorporating in Kitchens (Built-In)

To build-in your washing machine you will need the Built-In Installa-
tion Kit (E No. 605 898 832).

Protection Against Touching Under Work Surfaces

1
Warning! When the appliance is built-in, the top of the appliance
must be fitted with an earthed sheet metal cover (E No. 605 898 832).
Only then may the washing machine be connected to the mains and
put into use.
Free-standing models can be built-in underneath the work surface
after removal of the worktop fitted to the appliance. This results in the
height of the appliance being reduced to 82cm (see "Appliance Dimen-
sions").

Removing the Worktop

1.Remove the screws (1) on the rear of the
0
appliance.
2. Pull the worktop to the rear to the stop (2)
and lift off.
3. Press in the catches on the guides (3) and
remove the guides by twisting (4).
Installation and Connection Instructions
45