Replacing A Turn Signal Light Bulb; Replacing The License Plate Light Bulb; Replacing An Auxiliary Light Bulb - Yamaha WR125R Owner's Manual

Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
1. Screw
2. Turn signal light lens
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
[ECA11191]
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU24204
Replacing the license plate
light bulb
1. Remove panel B. (See page 6-7.)
2. Remove the socket (together with
the bulb) by pulling it out.
1. License plate light bulb
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the panel.
EAUM2620
Replacing an auxiliary light
bulb
If the auxiliary light bulb burns out, re-
place it as follows.
1. Remove the headlight unit. (See
2. Remove the auxiliary light socket
1. Auxiliary light bulb
3. Remove the burnt-out bulb by pull-
4. Insert a new bulb into the socket.
5. Install the auxiliary light socket (to-
6. Install the headlight unit.
6-31
page 6-29.)
(together with the bulb) by pulling it
out.
ing it out.
gether with the bulb) by pushing it
in.
EAU45222
6