Table of Contents
Advertisement
Specification
We recommend that you install the CD-ROM on the Secondary IDE
channel as the master device (MA), and the CD-R/RW on the Secondary
IDE channel as the slave device (SL). Please follow the steps below to
fulfill this arrangement.
First make sure that your Secondary IDE cable has two ports available for two
IDE devices. If not, ask your main board vendor or purchase one from computer
hardware stores.
If the CD-ROM drive was installed in the Primary IDE channel, disconnect it
from the Primary IDE cable.
Adjust the Device Configuration Jumper of the CD-ROM drive to "Master" (MA)
position.
Adjust the Device Configuration Jumper of the CD-R/RW to "Slave" (SL)
position.
4. From your main board, find out the 40-pin Secondary IDE interface cable. Then
connect them to your CD-R/RW. Please do notice that the color edge of the IDE
cable must be aligned with PIN 1 of the IDE controller.
-- E-10 --
Pin1
Advertisement
Table of Contents
