What To Do If; Remedying Small Malfunctions - AEG FAVORIT 60870 User Information

What to do if...

Remedying small malfunctions

If one of the following fault codes is displayed in the multi-display dur-
ing operation:
– Fault codeÅ 10 (Problems with water inlet),
– Fault codeÅ 20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the cycle that has
started. The cycle will continue.
With other fault codes ("Å " followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact your local Service Force
Centre and inform them of the fault code.
Malfunction
The cycle indicator for the
selected dishwashing cycle
is flashing:
the control indicator WA-
TER is lit,
Å 10
fault code
played in the multi-display
(Problems with water in-
let).
Possible cause
Water tap is blocked with
limescale or faulty.
The tap is turned off.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
is dis-
Filters in the base of the
washing compartment are
blocked.
Water inflow hose
has not been correctly posi-
tioned.
Remedy
Check the water tap and
have it repaired if necessary.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Press the button for the
dishwashing cycle that has
started;
then abort the dishwashing
cycle (see section: Starting
a dishwashing cycle);
clean filters (see section:
Cleaning the filters).
Check the position of the
hose.
27