Malfunction
The cycle indicator for the
selected dishwashing cycle
is flashing,
fault code
played in the multi-display
(there is water in the dish-
washer's internal dispens-
er).
Fault code
played in the multi-dis-
play.
The control indicator FIL-
TER is lit.
The cycle is not starting.
28
The sink outlet is blocked.
Å 10
is dis-
Water drain hose
has not been correctly posi-
tioned.
Å 30
is dis-
The anti-flood system has
been triggered.
The indicator FILTER is there
to remind you to check the
dishwasher's filters occa-
sionally and to clean them,
if necessary. It lights up at
regular intervals, regardless
of how clean the filters are.
The mains plug is not
plugged in.
A fuse in the house's wiring
system is defective.
For dishwasher models with
a delay start timer:
A start time has been se-
lected.
Possible cause
Remedy
Clean out sink outlet.
Check the position of the
hose.
First shut off the water tap,
then switch off the appli-
ance and contact the Cus-
tomer Care Department.
The indicator goes out auto-
matically at the start of the
next dishwashing cycle.
Plug in the mains plug.
Replace the fuse.
If the dishes are to be
washed immediately, cancel
the delay start.