Advertisement
WIRE SELECTI ON G U IDE
Moto r
Hi Per fo rm ance
Rating
1.6
DRAIN CONNECTION AND SYSTEM TEST
Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the
pump couplings and make sure they are hand-tight. Clean the whirlpool and fill with water to a point 2" above the top of
the highest jet. Recheck the pump couplings and make certain that they are not leaking. (Although the pump couplings
are factory tightened and inspected, some loosening may have occured during transit.)
connected to the electrical supply and turn the whirlpool on.
whirlpool is running.
POST INSTALLATION CLEAN-UP
Remove all construction debris from bath. Tile grout can be removed with a wooden popsicle stick or tongue depressor.
Do not use wire brushes or any other metal implement on bath surface.
Post installation clean-up generally can be completed using warm water and liquid dishwashing detergent. Stubborn dirt or
stains may be removed using granular Spic and Span ® mixed with water.
Painter's naphtha can be used to remove excess adhesives and/or wet oil-base paint.
HARSH CHEMICALS SHOULD NEVER BE USED ON ACRYLIC SURFACES.
Abrasive cleaners must not be used since they will scratch and dull the surface. Dulled areas can be restored by rubbing
with a white automotive-type polishing compound and waxing with a liquid wax.
752500-100 REV. G
M ax imum di st an ce f rom
f us e box t o m ot o r
50'
10 0'
15 0'
1 15V P ow e r L in e
12
12
10
T he siz es shown on th i s
chart are recomm en da ti on s
200'
f or cop pe r con ductors
8
Check for leaks around all piping connections while the
(4)
SPIC AND SPAN ® IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE
on ly. Always f oll ow
local an d n ation al
e lectrical co des
Make sure the whirlpool is
Advertisement
