Wearing The Dial Pad With The Belt Clip - Plantronics CT14 User Manual

Wearing the Dial Pad with the Belt Clip

Cable route
1
Plug the headset cord into the 2.5mm jack on the top of the dial pad.
2
Route the cord through the dial pad's cable routing slot on the back of
the dial pad.
Attach the belt clip only after you have routed the cord.
3
Insert the tabs on the sides of the belt clip into the holes on either side
of the dial pad.
Press the belt clip down until it clicks into place.
To remove the belt clip pull one side of the belt clip to release the tab
from the hole.
5