Seams; Basting Tupstrtrhr Q; Darning - White 310 Operator Instructions Manual

SECTION V
STRAIGHT STITCH:
SEAMS
r
L.
The normal stitch length for most fabrics
is between 2—3 but the length chosen
should depend on the fabric and area of
usage,
Usually, heavier fabrics require
longer stitches and lighter weight fabrics
require shorter stitches, For curved seams
and bias cut areas use a shorter stitch
length
BASTING/TOPST ITCH ING
Sewing a seam with a longer stitch is useful
for temporary seams prior to fitting.
Basting stitches also may be used when
gathering in fullness.
Topstitching can be done very effectively
with the long straight stitch. For a bolder
stitch, two threads of the same type can
be threaded through one needle (size 14
or 16>. A heavier thread such as button
hole twist may be used for topstitching,
but be sure to use a larger needle (size 16
or 18).
DARNING
Worn spots or small holes can be darned
very easily. Use of an embroidery hoop is
optional depending on the fabric. A fine
thread is recommended so that the fabric
and thread will blend together invisibly.
Trim the ragged edges from the area to be
darned.
Hold the threads to start, then
move the fabric slowly backwards and
forwards while running the machin very
fast to fill the area. Professional results
will be attained by moving the fabric in
a figure eight pattern while sewing. After
filling in the area
lengthwise, reweave
with crosswise stitches in the same manner.
Pattern:
Length: 0
Feed Dog: Down
Pressure: 0
Foot: Straight Stitch or AP-Purpose
Pattern,
Length: 2—3
Feed Dog: Up
Pressure: Full
Foot: Straight Stitch or All-Purpose
Pattern:
Length: 4 5
Feed Dog. Up
Pressure: Full
Foot: Straight Stitchor All—Purpose