Installing Software; Installing Drivers And Software In Windows; Software Installation Prerequisites - ATI Technologies ALL-IN-WONDER X800 Series Installation And Setup User's Manual

CHAPTER 3:

Installing Software

This chapter will guide you through the installation of the drivers and
software associated with your ALL-IN-WONDER® X800 Series card.
Installing Drivers and Software in
Windows®
You will need to install the ALL-IN-WONDER® X800 Series drivers and
software in the following cases:
• After you have installed the card in your system.
• After you have reinstalled or upgraded your operating system.
This procedure applies to Windows® 2000 and Windows® XP.
Linux drivers and installation instructions are available from
ati.com/support

Software Installation Prerequisites

To install or remove the drivers, you must have administrator rights or be
logged on as a user with administrator rights.
Your operating system must be installed and running before you can install
the ALL-IN-WONDER® X800 Series drivers. You must also have Service
Pack 1 (or higher) for Windows® 2000 or Windows® XP installed.
Make sure your monitor cable is properly attached before you begin.
Note: The installation dialog will display in English if your operating
system's language is not supported.
To install ATI drivers and software
1
Start your system. When the Found New Hardware Wizard
comes up, click Cancel. When the System Settings Change
window asks you to restart your computer, click No.
Installing Drivers and Software in Windows® 25