Pro-Form 831.283521 User Manual page 7

5. The Console (5) requires four "D" batteries (not includ-
ed); alkaline batteries are recommended. Remove the
indicated screw from the battery drawer, and pull the
battery drawer open. Insert four batteries into the bat-
tery drawer; make sure that the batteries are orient-
ed as shown by the markings inside the battery
drawer. Close the battery drawer and reattach the
screw. Note: When the batteries are installed correctly,
the fan will turn on for a moment.
6. Identify the Left Handlebar (9), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Legs (79); make sure that the Handlebar
Leg is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar to the
Handlebar Leg with two M8 x 45mm Button Bolts (50)
and two M8 Nylon Locknuts (46). Make sure that the
Nylon Locknuts are inside of the hexagonal holes.
Do not fully tighten the Button Bolts yet.
Apply a generous amount of the included grease to the
Pivot Axle (97) and to the two M8.5 Washers (53). Insert
the Pivot Axle into the Upright (2) and centre it. Reapply
grease to both ends of the Pivot Axle.
Slide a Handlebar Spacer (25) onto the short tube on the
Left Handlebar (9), and rotate the Handlebar Spacer so
the arrow is pointing toward the floor. Then, slide the Left
Handlebar onto the Pivot Axle (97). Make sure that the
Left Handlebar is on the correct side. Turn an M8 x
25mm Patch Screw (22) with an M8.5 Washer (53) and
a Wave Washer (95) into the end of the Pivot Axle.
Attach the Right Handlebar and the other Handlebar Leg
(not shown) to each other and the Pivot Axle (97) in the
same way. Next, tighten the two M8 x 25mm Patch
Screws (22) into the Pivot Axle. Press the small tabs on
the Handlebar Caps (23) into the two Handlebar Spacers
(25).
7. Hold the lower end of the left Handlebar Leg (79) inside
of the left Front Flex Bracket (17). Apply a small
amount of grease to an M10 x 78mm Button Bolt (27).
Attach the left Handlebar Leg to the left Front Flex
Bracket with the Button Bolt, two M10 Washers (38),
and an M10 Nylon Locknut (29). Do not overtighten
the Nylon Locknut; the left Handlebar Leg must be
able to pivot freely.
Attach the right Handlebar Leg (79) to the right Front
Flex Bracket (17) in the same way.
See step 6. Tighten the M8 x 45mm Button Bolts (50)
in the Handlebar Legs (79). See step 3. Tighten the
M10 x 88mm Button Screw (63).
5
Screw
6
9
53
22
95
23
50
7
79
38
38
27
17
Grease
7
5
Batteries
Battery
Drawer
Grease
Tube
97
2
25
Arrow
46
Hexagonal
Holes
79
79
29
17