This product has many features for making its use more pleasant
and enjoyable. Safety, performance, and dependability have
been given top priority in the design of this product, making it
easy to maintain and operate.
GROUNDING THE GENERATOR (See Figure 1)
To avoid the risk of shock or electrocution, the generator
must be properly grounded. The nut and ground terminal
on the frame must always be used to connect the
generator to a suitable ground source. The ground path
should be made with 0.75m
terminal of the ground wire between the lock washer
and the nut, and tighten the nut fully. Connect the other
end of the wire securely to a suitable ground source.
ImpORTANT sAfETy INsTRUCTIONs
Read and understand all instructions. Failure
to follow all instructions listed below may result
in electrocution, fire, and/or carbon monoxide
poisoning, which will cause death or serious injury.
National Electric Code requires the generator to be
grounded to an approved earth ground. Before using
the ground terminal, consult a qualified electrician,
electrical inspector, or local agency having
jurisdiction for local codes or ordinances that apply
to the intended use of the generator.
sAVE THEsE INsTRUCTIONs
This manual contains important instructions that should be
followed during installation and maintenance of the generator
Do not allow children or untrained individuals to use this
Never start or run the engine inside a closed or partially
enclosed area. Breathing exhaust fumes will kill you.
Wear eye protection as well as hearing protection when
operating this equipment.
Keep all bystanders, children, and pets at least 3m away.
Wear sturdy and dry shoes or boots. Do not operate while
Do not operate the generator when you are tired or under
the influence of drugs, alcohol, or medication.
Keep all parts of your body away from any moving parts
and all hot surfaces of the unit.
size wire. Connect the
Product users in some states, must comply with fire
prevention regulations. This product is not equipped with
a spark arrestor. Check with the federal, areas, or local
authorities in your area before use.
Do not touch bare wire or receptacles.
Do not use the generator with electrical cords which are
worn, frayed, bare, or otherwise damaged.
Before storing, allow the engine to cool.
Do not operate the generator in rain, snow, or wet weather.
Empty fuel tank, close fuel valve, and restrain the unit from
moving before transporting in a vehicle.
Allow engine to cool for five minutes before refueling.
To reduce the risk of fire and burn injury, handle fuel with
care. It is highly flammable.
Do not smoke while handling fuel.
Store fuel in a container approved for unleaded fuel.
Position the unit on level ground, stop engine, and allow
to cool before refueling.
Loosen fuel cap slowly to release pressure and to keep
fuel from escaping around the cap.
Tighten the fuel cap securely after refueling.
Wipe spilled fuel from the unit.
Never attempt to burn off spilled fuel under any
Use only authorised replacement parts and accessories and
follow instructions in the Maintenance section of this manual.
Use of unauthorised parts or failure to follow Maintenance
instructions may create a risk of shock or injury.
Maintain the unit per maintenance instructions in this
Inspect the unit before each use for loose fasteners, fuel
leaks, etc. Replace damaged parts.
The generators vibrate in normal use. During and after
the use of the generator, inspect the generator as well as
extension cords and power supply cords connected to it
for damage resulting from vibration. Have damaged items
repaired or replaced as necessary. Do not use plugs or
cords that show signs of damage such as broken or cracked
insulation or damaged blades.