Download  Print this page

Spark Arrestor - AEG Powertools AGN3800B Original Instructions Manual

Portable generator set
Hide thumbs

Advertisement

to 1/4 turn for proper washer compression.
NOTE: An improperly tightened spark plug will become
very hot and could damage the engine.
CLEANING THE EXHAUsT pORT AND mUffLER
Depending on the type of fuel used, the type and amount of
oil used, and/or your operating conditions, the exhaust port
and muffler may become blocked with carbon deposits. If
you notice a power loss with your petrol-powered tool, you
may need to remove these deposits to restore performance.
We highly recommend that only qualified service technicians
perform this service.

spARK ARREsTOR

Product users in some areas, must comply with fire prevention
regulations. This product is equipped with a spark arrestor.
DRAINING fUEL TANK / CARBURETOR
When not using a fuel stabiliser, draining the fuel from the tank
and carburetor before storage may help prevent gum deposits
in the fuel system.
DRAINING THE fUEL TANK
See Figure 13.
Turn the engine switch OFF ( O ).
n
Close fuel valve.
n
Remove the fuel line from the barb by squeezing the
n
ends of the retaining clip and sliding the fuel line off.
Install one end of a drain line over the barb, and place
n
the other end in a fuel container large enough to catch
the fuel being drained from the tank.
Open fuel valve.
n
When the fuel has drained from the tank, close the fuel
n
valve and reinstall fuel line on barb.
English
DRAINING THE CARBURETOR
See Figure 2.
Turn the engine switch off ( O ).
n
Close the fuel valve.
n
Position an approved fuel container under the carburetor
n
drain screw to catch fuel; loosen the screw.
Allow fuel to drain completely into container.
n
Retighten drain screw.
n
NOTE: After draining the fuel tank and carburetor, start
the engine and allow it to run until the unit runs out of
fuel. Consult hazardous waste management guidelines in
your area for the proper way to dispose of used fuel.
TRANspORTING
Turn engine switch OFF ( O ).
n
Close the fuel valve.
n
Make sure engine and exhaust of unit is cool.
n
Keep unit level to prevent fuel spillage.
n
Do not drop or strike unit or place under heavy objects.
n
12

Advertisement

loading

  Related Manuals for AEG Powertools AGN3800B

  Related Content for AEG Powertools AGN3800B