Tuning To The Tv Using An Antenna Cable (Rf Cable), What To Do If You Get Picture Interference; Tuning Your Video Recorder To The Television; Setting Time And Date - Daewoo Video recorder Instruction Manual

Tuning your video recorder to the television

'Autoset' only will appear on your screen if your video has this function.
'Autosearch' only will appear on your screen if your video has this function.
Auto Set or Search!
1
OK:confirm MENU:end
AUTO SET or SEARCH
PR03
UHF ------------ ----
2
76%
MENU:end
AUTO SET or SEARCH
setting
3
Please wait...
MANUAL SET
PR01 P-01 PRO6 P-06
PR02 P-02 PRO7 P-07
4
PR03 P-03 PRO8 P-08
PR04 P-04 PRO9 P-09
PR05 P-05 PR1O ----
PR+/-:select
OK:confirm MENU:end
The video's automatic tuning system usually gets the best results. In poor reception areas, fine tuning
may improve reception. Choose the station and tune it in using the
buttons on the remote control to enter the programme number you want to store the station on.

Setting time and date

CLOCK SET
Time 11:41
1
Date 20/09/1999(MON)
0-9:setup(hour)
/ :correct
OK:confirm MENU:end
CLOCK SET
Time 11:41
2
Date 20/09/1999(MON)
0-9:setup(minute)
/ :correct
OK:confirm MENU:end
3
8
Press on your remote control.
If you do not see this picture, check that the video is connected
properly.
Press OK for 'Auto Set' or 'AutoSearch'.
Unless you are living in an area with poor reception,'Auto Set' or 'Auto Search'
tunes in all the stations you can receive in your country and sorts them in a common
order, for example, BBC1 on programme 1, BBC2 on programme 2 and so on.
See page 11 and page 12 if you need to change any of the automatic settings. You
should finish stage 4 before you go to page 11 or page 12.
The clock is also set automatically. If the clock has not been set, the clock setting
screen will appear.
Please see 'Setting time and date' below.
If you want to change the station names, see page 11.
If you want to change the programme locations see page 12. You need to change
programme locations if the stations are not in order, for example, BBC1 on
programme 1, BBC2 on programme 2 and so on.
Press MENU to end.
Important: If you switch the video off at the mains supply overnight, you do
not have to retune the video. Simply press
remote control to restore all the programme settings. See below to set the
time and date.
If the 'CLOCK SET' display is not already on the screen press MENU.
Choose 'VCR SET UP' by pressing PR- twice, then press OK.
Choose 'CLOCK SET' by pressing OK.
Once the 'CLOCK SET' display is on the screen, move to the position
you want to change by pressing
Use the number buttons 0 to 9 on the remote control to enter the
correct time and date.
Press OK to confirm the settings, and press MENU to end.
and then MENU on the
and
buttons. Use the number
or .