Table of Contents
Advertisement
Turning off the Projector
To turn off the projector completely, stop projection as described above. Once
projection has stopped and the indicator light is steady orange, it is safe to switch
off the projector with the power switch.
Indicator Light States:
Light
Off
No power, OR, if power is on, there is a problem with bulb or
projector. Safe to turn off.
Steady orange
Standby mode (projection stopped); safe to turn off.
Flashing green
Lamp turning on. If projection turns off and light flashes green,
the projector temperature is too high. See the troubleshooting
section for possible causes and solutions.
Steady green
Projecting at maximum brightness.
Flashing orange Lamp cooling off; will take approximately 90 seconds.
Flashing red
Fan not functioning; projector will automatically shut down.
Contact technical support.
REMEMBER: Only turn off the projector when the light is steady orange
or off to avoid lamp damage.
Packing
To assist you in packing your Digitarium Alpha projector, a small white circle is
attached to one corner of the transit case base foam. The lens of the Digitarium
Alpha projector should be placed in the corner marked by this circle. This lines up
the lens with a hole in the foam-lined top of the transit case, putting less pressure
on the lens.
If your lens cap seems loose or you will be transporting your projector far, we
recommend using a strip of masking tape to keep the cap on and the lens
protected during transit.
Meaning
Digitarium Alpha User Manual 8
Advertisement
Table of Contents
