The Water Connection Kit - Westinghouse WSE7000 User Manual

tHE wAtER CoNNECtioN Kit

tHE ExtERNAL wAtER fiLtER Kit
An external water filter and connection kit has been supplied
for use with your Ice & Water refrigerator The external filter design
allows more space within the refrigerator and provides double
the life of previous filters reducing the cost of replacement
The filter is designed to significantly reduce chlorine, taste,
odour, heavy metals, turbidity (cloudiness) and scale build up
The included water tube allows quick connection to the filter
and is designed for high durability and kink resistance This
filter is designed only to be used with a potable water supply It
should not be used on water that is micro biologically unsafe
or with water of unknown quality The filter should be replaced
every 12 months The service life of the filter may be reduced
in water supplies that contain an excess of particles or other
impurities. Reduced flow rate is an indication that a new filter
is required Failure to replace the filter when required can
affect the function of the ice maker Service calls caused by
a failure to replace the filter are not covered by warranty
To install refer to page the 'Water Filter Kit Installation'
Instructions
CAUTION
Follow installation instructions supplied with new filter or
those provided in the 'Changing the water filter' section.
CHANGiNG tHE LiGHt bULb
REfRiGERAtoR LiGHt
1 Switch off the power at the power point and remove
the refrigerator's power cord from the power point.
Check the temperature settings and write them down
diagram A
2 Unclip the light lens by inserting your fingers at
point 1 in diagram A
3. L ift the light lens until it is clear of the housing and
unscrew the light bulb
4 Unscrew the light bulb and replace it with a bulb that is
the same as the original If, when you remove the light
bulb the small rubber 'O' ring comes out with the bulb,
fit the 'O' ring over the new bulb and screw bulb into
the socket (see diagram at the right of the page)
WARNING
Never insert your finger into the light bulb socket to check
for the presence of the 'O' ring.
5. R eplace the light lens by inserting the tab on the lens
at point 2 and pushing in the lens with both hands at
point 3, see diagram B
6 Turn the refrigerator back on
diagram B
care & maintenance 31