Gemini Remote Control Helicopter User Manual page 5

FLYING YOUR HELICOPTER
GETTING STARTED
Band Selection
1. Select the frequency band on the controller. (A, B or C)
2. Move the chopper's switch to the ON position.
The helicopter will light up, indicating it is on.
3. Carefully hold the chopper in one hand, be sure the blades are clear of any
obstacles. Move the throttle (left joy stick) on the remote control
completely down, then completely up, and then down again to "set" the
band. If done properly, the Red light on the remote will stop blinking and
the chopper will automatically sync. If Red light does not stop blinking, turn
above steps.
4. Place the chopper on the ground with the tail pointed toward you and the
nose facing away from you.
5. Make sure your surroundings are clear of obstacles before operating.
ying multiple choppers in the same room set each one to a
erent band (A, B, or C)
Driving your Helicopter
The same remote control can be used to drive your helicopter. Gently move the
Left joystick to move the helicopter forward. Move the Right joystick right or
left to change the direction of the helicopter.
INTERFERENCE
Some radio frequencies or other R/C units nearby can cause interference and
poor performance. Try to move away from the source of the interference.
Trimming Helicopter/Direction Control
Located on the top of the Controller is the Trim Control. When the helicopter
y straight, use the Trim Control to adjust the alignment.
the top right side to adjust.
1. When the helicopter is spinning clockwise, turn the Rudder Trim Knob
counterclockwise to adjust. (See Diagram A)
2. When the helicopter is spinning counterclockwise, turn the Rudder Trim
Band
Selector
, turn the remote back on and repeat the
ight, use the Rudder Trim Knob on
5
C
B
A