Battery Installation - Gemini Remote Control Helicopter User Manual

This product requires the following batteries:
• 1 x 3.7V rechargeable Li-Poly battery - Helicopter (included)
• 6 x AA batteries - Controller (not included)
INSTALLING BATTERIES IN THE CONTROLLER
1. Using a Phillips-head screwdriver, remove the screw from the battery
compartment cover.
2. Insert six (6) AA batteries, making sure to follow the battery polarity
(+ and -) as shown in the drawing on the product.
3. Replace the battery compartment cover and secure with the screw.
4. Turn on the remote. If the batteries are properly installed, the Red LED
light will blink. If the Red LED does not come on when you turn the
remote on, remove the batteries and reinstall. Some brands of batteries
have small size variations that can impact the connection.
CHARGING
1. Make sure the controller is turned ON.
the front center of the
controller, and take out the charging wire.
3. Make sure the helicopter power is OFF.
Insert the charging plug into the charging
outlet on the helicopter.
4. The Green LED on the remote will turn on
when charging is complete.
When fully charged, remove plug from
the helicopter.
REQUIRES APPROXIMATELY
40-45 MINUTES CHARGE
FOR A FULL 5-6 MINUTE FLIGHT.

BATTERY INSTALLATION

Charging
Socket
3
BOTTOM OF HELICOPTER
ON/OFF
SWITCH
OFF ON
CHA