3.5. LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are
shown below.
LAN Port
IP address
Subnet Mask
DHCP server function
IP addresses for
distribution to PCs
3.6. ISP Information
Before configuring this device, you have to check with your ISP (Internet Service Provider)
what kind of service is provided such as PPPoE, PPPoA, RFC1483, or IPoA.
Gather the information as illustrated in the following table and keep it for reference.
PPPoE VPI/VCI, VC-based/LLC-based multiplexing, Username,
PPPoA VPI/VCI, VC-based/LLC-based multiplexing, Username,
RFC1483 Bridged VPI/VCI, VC-based/LLC-based multiplexing to use Bridged
RFC1483 Routed VPI/VCI, VC-based/LLC-based multiplexing, IP address,
192.168.1.254
255.255.255.0
Enabled
100 IP addresses continuing from
192.168.1.100 through
192.168.1.199
Password, Service Name, and Domain Name System (DNS)
IP address (it can be automatically assigned by your ISP when
you connect or be set manually).
Password, and Domain Name System (DNS) IP address (it
can be automatically assigned by your ISP when you connect
or be set manually).
Mode.
Subnet mask, Gateway address, and Domain Name System
(DNS) IP address (it is fixed IP address).
20
WAN Port
The PPPoE function is
enabled to
automatically get the
WAN port
configuration from the
ISP, but you have to
set the username and
password first.