Table of Contents
Advertisement
Chapter 4 – Reset and Network ID Buttons Setting
There are 2 buttons on the device, one is Reset button the other is Network ID button.
4.1 Reset Button
Push this button can reset to the factory default settings. Be careful, when you press the reset
button, please remove the Ethernet cable (RJ-45cable) first, and then press the reset button.
After press the reset button for less than 3 seconds and then wait the PWR LED light again.
Don't power off when the device is in reset process.
4.2 Network ID Button
The HomePlug AV powerline communication devices can form multiple logical networks over a
common powerline or coax medium. There are many situations when it is desirable to add new
devices to, or remove old devices from, a HomePlug AV logical network.
Push this button to accomplish using HomePlug AV Simple Connect Technology.
Network ID Button trigger state conditions
"Adder state" for a device providing the NMK for an existing AVLN
"Joiner state" for a device that will join an AVLN
Pushing buttons on any two devices results in one of them becoming an "adder" and the other
one a "joiner"
17
Advertisement
Table of Contents
