Datos Técnicos; Instalación; Colocación; Conexión Elétrica - CORBERO FD 5140 I/1 Instruction Booklet

Table of Contents

Advertisement

Available languages

Available languages

DATOS TÉCNICOS
Clase de eficiencia
Capacidad neta del frigorífico en litros
Capacidad neta del congelador en litros
Consumo energético en kWh/día
Consumo energético en kWh/año
Capacidad de congelación en kg/día
Tiempo de aumento de la temperatura de –18°C a –9°C por hora
Los datos técnicos se indican en la placa-matrícula situada sobre el lado izquierdo interno del aparato.
INSTALACIÓN
Colocación
Situar el aparato lejos de fuentes de calor, como:
radiadores, estufas, exposición directa a los rayos
del sol, etc.
Conexión eléctrica
Antes de enchufar el aparato, asegurarse de que la
tensión y la frecuencia indicadas en la tarjeta
matrícula, correspondan a las de la instalación
doméstica. Se admite una oscilación del 6% sobre
la tensión nominal.
Para el funcionamiento a tensiones distintas, habrá
que utilizar un autotransformador de potencia
adecuada. Asegurarse de que la toma de corriente y
el enchufe sean compatibles entre sí sin tener que
interponer reducciones ladrones o adaptadores
varios. Si fuera necesario, cambiar la toma de la
instalación de la casa.
Es indispensable conectar el aparato a una toma
de tierra eficaz.
Para ello el enchufe del cable de alimentación está
dotado de un adecuado contacto adecuado. Si la
toma de corriente de la instalación doméstica no
estuviera conectada a tierra, conectar el aparato a
una instalación de tierra, conforme a las leyes en
vigor, consultando para ello con un técnico
especializado.
El fabricante declina toda responsabilidad en el
caso que esta norma no sea respetada.
8
B
184
40
0,90
329
4
20
Este aparato es conforme a las siguientes
Directivas Comunitarias:
- 87/308 CEE del 2/6/87 relativa a la supresión de
interferencias radio.
- 73/23 CEE 19/02/73 (Baja tensión) y
modificaciones sucesivas;
- 89/336 CEE 03/05/89 (Compatibilidad
electromagnética) y modificaciones sucesivas.
Atención
Se debe poder desenchufar el aparato; por lo tanto
una vez efectuada la instalación es necesario que el
enchufe no quede escondido

CUSTOMER SERVICE AND SPARE PARTS

If the appliance is not functioning properly, check
that:
the plug is firmly in the wall socket and the mains
power switch is on;
there is an electricity supply (find out by plugging
in another appliance);
the thermostat knob is in the correct position.
If there are water drops on the bottom of the
cabinet, check that the defrost water drain

TECHNICAL INFORMATION

Energy Efficiency Class
Fridge Net Capacity lt.
Freezer Net Capacity lt.
Energy Consumption kWh/24h
Energy Consumption kWh/annuo
Freezing Capacity kg/24h
Rising Time
The Technical info are on the rating plate situated on the left inside the appliance.
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For building into kitchen units follow the special "
Building-in" instructions given.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
opening is not obstructed (see "Defrosting"
section).
If your appliance is still not working properly after
making the above checks, contact the nearest
service centre.
To obtain fast service, it is essential that when you
apply for it you specify the model and serial number
of your appliance which can be found on the
guarantee certificate or on the rating plate located
inside the appliance, on the bottom left-hand side.
B
184
40
0,90
329
4
20
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Attention
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents