WARNINGS It is most important that this instruction book The inner lining of the appliance consists of chan- should be retained with the appliance for future nels through which the refrigerant passes. If these reference. Should the appliance be sold or trans- should be punctured this would damage the appli- ferred to another owner, or should you move ance beyond repair and cause food loss.
INSTALLATION If this refrigerator featuring magnetic door seals is The manufacturer declines to accept any liability if to replace an older appliance having a spring lock this accident-prevention procedure is not followed. on the door or lid, be sure to make that spring lock This appliance complies with E.E.C.
Page 5
For appropriate venting, follow indications in Fig. 2. Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance Fig. 2 50-min. cm 200 hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance.
Page 6
Position the runners (H) at the top and bottom of the Remove the little plates and make the holes with a di- inside of the kitchen unit as shown in Fig. 8 and mark am. of 2 mm. Replace the little plates over the runners the position of the external holes.
Starting-up and temperature regulation Freezing is completed after 24 hours from the start. On the inner door of the compartment you Insert the plug into the wall socket. Open the refriger- will find a list of foods followed by a number. These ator door and turn the thermostat knob, to be found numbers indicate the maximum period of time for on the top right hand side of the inner liner, clockwise...
Food refrigeration Positioning the door shelves To achieve the best results with the refrigerator com- To permit storage of food packages of various sizes, partment, you should follow one or two very simple the door shelves can be adjusted in height. rules: To make these adjustments proceed as follows: Do not put warm foods or evaporating liquids in the...
Fig. 15 However, when the ice becomes very thick on the in- ner liner, complete defrosting should be carried out and it is advisable to carry out this operation when the appliance is empty. To carry out complete defrosting of the ( freezer compartment proceed as follows: Unplug the appliance from the power supply or set the thermostat to position «O».
MAINTENANCE Replacing the interior light bulb Unplug the appliance before carrying out any maintenance operation. The light inside the refrigerator compartment is easy Clean the interior periodically with lukewarm water to get at through the opening in the light holder. and some sodium bicarbonate;...
Need help?
Do you have a question about the FD 3290 I and is the answer not in the manual?
Questions and answers