Description Of The Appliance - Electrolux ER7926B Instruction Book

DESCRIPTION OF THE APPLIANCE

E
MIN MAX
COOL FLOW CONTROL
F
G
H
I
3 - 3 -
3 - 3 -
3 - 4
1 -
J
A- Thermostat control for fridge and freezer compartments
B- Dairy compartment
C- Storage shelves
D- Bottle storage shelf
E- Air circulation slider control
F- Wire shelves
G- Glass shelf
H- Salad drawers
I - Freezing/storage compartment
J- Frozen food storage
4
10 -
10 - 10 -
10 -
Door reversal directions
1. Disconnect from the electricity supply.
2. Remove all loose items, including food, store food
in a cool place.
3. Gently lay the fridge/freezer on its back with the
top held away from the floor by 5-8 cm (2-3
A
inches) of packing.
4. Remove the feets (B).
B
5. Remove bottom hinge (A).
6. Remove the freezer door by releasing it from the
middle hinge (C).
7. Unscrew the middle hinge.
8. Slide out the fridge door from pin (D), unscrew pin
(D) and then screw it down into the hinge
C provided on the opposite side, after having
removed the small plugs (I) which should then be
fitted on the opposite side.
D
9. Remove blanking plug (E).
10.Remove door closure device (F) from the upper
door and refit it on the opposite side of the bottom
door.
11. Remove door closure device (F) from the bottom
door and refit it on the opposite side of the upper
door.
12.Refit the blanking plug (E) on the opposite side.
13.Refit the fridge door and replace the middle hinge
to the left hand side.
14.Replace the door and bottom hinge (A) on the
opposite side.
15.Refit the feets (B).
Attention
After reversing the door check that the gasket is
sealing correctly to the cabinet. If the gasket is not
sealing correctly, apply warm air to the non-sealing
area using a hair dryer set to gentle heat.
This will make the rubber more supple and allow it to
revert to its original shape and seal correctly.
Door closure device
The appliance is provided with a door closure device
which guarantee a correct closing of the doors.
B
A
B
D715 PIED/M
C
P R 2 4 / 2
D
D590
I
I
I
E
F
D752
17