Cisco Aironet 1200 Series Hardware Installation Manual page 60

Removing a 2.4-GHz Radio
Remove the 2.4-GHz radio card from the mini-PCI connector by performing the following operations:
Step 2
Push the card-retaining clips (on each side of card) away from the card (see
a.
released, the radio card springs up (see
Figure 5-3
1
Grasp the radio card only on the edges, being careful not to touch components on the board or the
b.
gold connector pins.
Remove the 2.4-GHz card from the mini-PCI connector.
c.
Place the removed 2.4GHz radio card into an anti-static bag.
Step 3
For instructions on installing a new radio card, go to the
Cisco Aironet 1200 Series Access Point Hardware Installation Guide, OL-2155-02
5-6
Location of Retaining Clips on 2.4-GHz Radio Card
1
Card-retaining clips
Figure 5-4).
1
MAIN AUX
"Installing a 2.4-GHz Radio"
Chapter 5 2.4-GHz Radio Upgrade
Figure 5-3). When
section.
OL-7043-02