Cisco Aironet 1200 Series Hardware Installation Manual page 39

Chapter 3 Basic Configuration
When using IPSU to change the SSID in a dual-mode access point, only the SSID for the 2.4-GHz radio
Note
is changed from the default value.
Follow these steps to assign an IP address and an SSID to the access point:
Step 1 Double-click the IPSU icon on your computer desktop to start the utility.
Click the Set Parameters radio button in the Function box (see
Step 2
Figure 3-2
Enter the access point's MAC address in the Device MAC ID field. The access point's MAC address is
Step 3
printed on the label on the bottom of the unit. It should contain six pairs of hexadecimal digits. Your
access point's MAC address might look like the following example:
004096xxxxxx
Note
Enter the IP address you want to assign to the access point in the IP Address field.
Step 4
Enter the SSID you want to assign to the access point in the SSID field.
Step 5
Note
Click Set Parameters to change the access point's IP address and SSID settings.
Step 6
Click Exit to exit IPSU.
Step 7
OL-7043-02
IPSU Set Parameters Screen
The MAC address field is not case-sensitive.
You cannot set the SSID without also setting the IP address. However, you can set the IP address
without setting the SSID.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide, OL-2155-02
Using the IP Setup Utility
Figure 3-2).
3-5